10A~100A Plastic Cover Solid State Relay DA DD AA Single Phase DC Control AC 220V to 3-32VDC SSR-10DA 25DA 40DA(60)

relayAttention:Solar equipment is a mixed load, we do not recommend using solid state relays.If you want to try, you need to buy a solid state relay with 10 times the current.At the same time, if the solid state relay does not work normally on the solar equipment, we do not provide return service.STEP 1: Choose a correct control ModeAA- AC Control ACDA- DC Control ACDD- DC Control DCSTEP 2: Choose a correct typeCurrent of Equipment/Ratio = Current of SSRPS: The Ratio depend on the kind of your loading equipment.Resistive load :70%, Inductive load:30%STEP 3: Choose a suitable heat sink.During the useage of SSR, it will give out a lot of heat, so in order to extend the life of your SSR, please install a heat sink , also if the current is over 60A,the cooling fan also required.NOTICE:The inside of the solid-state relay is a semiconductor. A semiconductor switch is a non-physical contact switch. if use a multimeter diode or resistor to test ,it always show a high-impedance state, (multimeter light red).According to the conventional detection methods of solid state relays: a load is required to test the switching state. Using an incandescent lamp as a dummy load is an obvious way to test continuity.

• relay